This is an old revision of the document!

<note tip> **after we set up the devices, we need to configure the softphone. Inside calls can be realized when the soft phone has been successfully registered.** </note> ==== Configure the softphone ==== ==== Download X-Lite ==== Download：[[http://www.counterpath.com/x-lite.html]] In the x-lite's homepage, click the {{:zh:新手上路:downloadx.png?|}}Button to download the soft phone. In the download process, you can choose the flatform supported by the system. {{:zh:新手上路:download-win.png?|}} Start to download and choose the path. {{:zh:新手上路:start.png?|}} ===Install X-Lite=== Double-click the X-Lite_Win32_4.1_63214.exe setup. {{:zh:新手上路:xlite.png?|}} Click Next to continue {{:zh:新手上路:xlite1.png?|}} Agree and Continue {{:zh:新手上路:xlite2.png?|}} Next {{:zh:新手上路:xlite3.png?|}} Select the path and continue {{:zh:新手上路:xlite4.png?|}} Next {{:zh:新手上路:xlite5.png?|}} Click Install to complete the installation {{:zh:新手上路:xlite6.png?|}} Finally click the Finish button, and the installation of the X-Lite is successfully done. ===SIP Account settings=== To set the SIP account, you can see the SIP Account settings interface popping up the first time you run Xlite, or you may just choose SIP Account Settings to get into the inferface. {{:zh:新手上路:sip.png?|}} SIP account is corresponding to the an SIP-type device added in the system. Enter the system, open the device management page, and double-click a device record to open the interface: {{:en:newbie:x-lite00.png?|}} The red font identifies the corresponding relation between the relevant item in the deviced information and the SIP account settings in the Xlite. <note tip> User ID: the identification of the device Domain: the intranet IP address of the system Password: the password of the device Displayname: the caller name </note> {{:zh:新手上路:sip2.png?|}} Click OK to submit the setting If the settings submitted has been successfully registered, you could see the word "available" in the interface. {{:zh:新手上路:sip1.png?|}} Now, the soft phone is configured. You can use it to realize callings, incoming calls and inside calls. You can dial extension numbers directly. When calls come in, their information will show up in the screen. {{:zh:新手上路:incoming.png?|}} **Continue to understand the [[Configure the ring group]]**