This is an old revision of the document!

<note tip> **After the extension is established, then we need to configure the softphone, until soft phone registered successfully to achieve internal calls。** </note> ===SIPAccount settings=== SIP account settings, right-click eyebeam interface, click the SIP Account Ssttings, click the Add button to add a SIP account {{:zh:新手上路:sip设置.png?|}} SIP account that corresponds to the SIP extension equipment, add a type system into the system, open the Device Manager page, double-click a device record to open the following interface: {{:en:newbie:addextension06.png?|}} The red font identifies the correspondence between the corresponding item in the eyebeam SIP account settings in the device information, <note tip> Displayname: Fill in the caller name User name: fill in the identity of the extension Password: Fill in the password of the extension Domain: fill in the system within the IP address </note> {{:zh:新手上路:astercc-1008.png?|}} Click OK to submit set <note important> **eyebeam than the xlite advanced eyebeam support multiple accounts, xlite only supports one account for telephone service processing. **</note> {{:zh:新手上路:accout.png?|}} You can select the desired account in the account before the check, and are free to choose the "Add" button to add a new account. <note tip> **eyebeamAlso support the g729 coding** </note> After the submission of such a normal registration, display Ready {{:1008.png?|}} * Common functions keys {{:en:newbie:eyebeam06.png?|}} So that soft phone configuration is successful, according to the need to use the soft phone outbound, inbound, and intercom. Can directly dial other extension number, incoming caller information pops up. {{:91008.png?|}} **Continue to understand [[Configure the ring group]] **