Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:newbie:add_the_extension [2012/02/12 08:08] shangy |
en:newbie:add_the_extension [2017/12/12 03:05] (current) |
||
|---|---|---|---|
| Line 43: | Line 43: | ||
| <note warning> | <note warning> | ||
| - | After the extension information is stored, the yellow tip strip appears, requirements overload, click the yellow tip strip, the system returns the information, suggesting overloaded successful, the yellow bar disappears. | + | After you saved the device information, a yellow prompt will show up, which asks you to reload. Click it and get it reloaded, then the yellow prompt will disappear. |
| </note> | </note> | ||
| - | In accordance with these methods, you can choose to add an extension to save the information is complete, we can be left under the list of PBX Management -> Device Manager list to see the added extension | ||
| + | Through these methods, you can add devices. After saving the information, we will see the devices added under the PBX management-> Devices. | ||
| {{:en:newbie:addextension05.png?|}} | {{:en:newbie:addextension05.png?|}} | ||
| - | Either an extension of the data, double-click the extension list, you can open the editing interface, double-click the black font edit, gray font can not be modified after the mouse leaves the system prompts successfully updated information is automatically saved. | + | Double-click whatever data in the device list to open the edit page. Black font means it is editable, and grey one isn't. When the mouse pointer left, the system will tell you that the information has been successfully saved. |
| {{:en:newbie:addextension06.png?|}} | {{:en:newbie:addextension06.png?|}} | ||
| - | Edit the blacklist: Click on the blacklist button, pop-up blacklist settings interface | + | Add blacklist: Click the button and enter the page of editing blacklist. |
| {{:en:newbie:addextension07.png?|}} | {{:en:newbie:addextension07.png?|}} | ||
| - | Completing the number, click on [Add to blacklist] button will appear in the table below, all is set to blacklist numbers, will not be transferred to your extension. | + | Enter the number, and click "Add blacklist" button, then the number will be in the following table. All the number in the blacklist cannot be out through to the device. |
| - | + | ||
| - | Edit the white list: Click this button to pop up white list settings interface | + | |
| + | Add whitelist: Click this button and enter the page of editing white list. | ||
| {{:en:newbie:addextension08.png?|}} | {{:en:newbie:addextension08.png?|}} | ||
| - | Fill in the number, click the [Add to White List] button, it will appear in the table below, once you set white list, and then only within the white list number to dial in to your extension. | + | Enter the number, click"Add whitelist" button, then the number will be in the following table. Once you set a white list, only the number in this list can be put through to the device. |
| - | + | ||
| - | Internal calls can be realized, ext created to be soft phone configuration is successful. | + | |
| - | **To enter [[Configuration eyebeam soft phone]] ** | + | Thus, devices have already set up. And when the soft phone are configured, the inside calls can be realized. |
| + | **To enter [[Configure eyebeam soft phone]] ** | ||
